Specifications Vibration Switch Main unit
Frequency Range |
Acceleration:7Hz~8kHz 3dB(10Hz~5kHz±1dB) Velocity:10Hz~1kHz±1.5dB Displacement:10Hz~300Hz±1.5dB |
Measurement Range |
Acceleration:10,100m/s2 Velocity:10,100mm/s rms Displacement:100,1000μm p-p |
Alarm output |
Upper Level individual setting I c Contact Max Capacity DC30V 1A for each Delay Time Setting Automatic Reset |
Signal Output |
4~20mA DC (Max Load Resistance 300Ω) |
Monitor Output |
3Vp-pAC FS 2VDC FS |
Power |
100VAC±10% 47~63 Hz |
Power Consumption |
5VA or smaller |
Ambient Environment |
0 ~ 50℃, 35 ~ 95%RH (No Condensation is allowed) |
Outside Dimension・Mass |
W74×H90×D72 mm・Approx. 250g |
Specifications of Piezoelectric Accelerometer
Model |
VP-A51 IW |
Detection |
Piezoelectric Accelerometer (with Build-in Pre-Amplifier) |
Resonance Frequency |
30kHz Approx. |
Frequency Range |
5~10000Hz±3dB |
Voltage Sensitivity |
5 mV/m/s2 (1G=9.80665m/s2) |
Measurable Max. Acceleration |
900m/s2 |
Power |
0.5~10mA Constant Current, Voltage 12~30V |
Output Impedance |
50Ωor lower |
Ambient Environment |
-30~110℃, (No Condensation is allowed) |
Construction |
Isolated・Water Proof IP54 |
Material (Outer Case) |
Stainless Steel |
Outside Dimension・Mass |
17Hex×39mm, 46g Approx. |
Cable Connection |
Upright TNC Connector |
Standard Composition
Name |
Model |
Remark |
Vibro Switch |
VM-90A |
― |
Pickup |
VP-A51IW |
Piezoelectric Accelerometer |
Pickup Cable |
― |
With a Connector at the end to Pickup and a Water proof cap Lengh:5 m (Note) |
Standard Accessories
|
― |
|
(Note) Contact us for other length than 5m. Expandable up to 200m
* Refer to P.82 for Cable Length