1.- Installation, connection and familiarization with the software.
2.- Familiarization with the navigation of an industrial controller (operator page
screen, trend display screen, etc).
3.- Setting up an industrial controller to accommodate the analog inputs/ outputs signals types and
engineering and electrical units.
4.- Function of a digital industrial controller.
5.- Configuration of analog inputs/ outputs signals of the industrial controller (electrical range,
engineering units, fault detector, etc).
6.- Setting alarms and diagnostics generation. 

To learn and to familiarize with the operation and structure of a process
control system under Profibus DP:
7.- Layout of a field bus system using the Profibus DP field bus.

8.- Study of OPC (OLE for Process Control) server function.
9.- Configuration of an industrial controllers networking through the
software: Master and slave assignment.
10.- Reading control variables and PID parameters and displaying them on
computer (PC) monitor.
11.- Scaling displays.
12.- Setting of an industrial controller using the front panel (configuration
level, parameter level, operation control level, etc.).
13.- Remote setting of an industrial controller using the control
configuration software (configuration level, parameter level, operation control level, etc.).

Unit (in metallic box), including:

2 Industrial Controllers modules. Each module is composed of:

Industrial Controller:
- ABB Controller CM30. Display: color 1/4 VGA TFT, liquid crystal display (LCD) with built-in backlight.
- Operator keypad: 6 tactile membrane keys.
- Control parameters:
   Proportional band: 0 to 999.9 %.
   Integral: 0 to 10000 s.
   Derivative: 0 to 999.9 s.
   Manual Reset 0.0 to 100 %.
- Autotune: On-demand calculation of control settings.
- Process alarms: Number: 8.

Analog inputs:
- Number: 2. Complete configurable process input.

Analog/Digital output:
- Number: 1. Type: configurable as analog or digital pulse.

Relays: Number: 2. Contact rating: 5A, 240V.
Communication (PC): RS-485 connector (Profibus DP).

Set Point Generator module:
2 Voltages selectable through a switch, which allows generate a step signal.
Amplitude: 0 to 10Vdc.
All process variables are accessible as analog signals at lab jacks.
Possibility of connection of external instruments via lab jacks (for example: line recorder, oscilloscope, etc).

Interface card, with RS-485 connector, to connect the industrial controllers through a field bus (Profibus DP) with the computer (PC).