 |
 |
The EDIBON Computer Control System is an OPEN, MULTICONTROL and REAL TIME CONTROL SYSTEM. So many parameters (sensors) and actuators can be controlled in an open way simultaneously.
The unit control elements are permanently computer controlled, without necessity of changes or connections during the whole process test procedure.
Simultaneous visualization in the computer of all parameters involved in the process.
Real time curves representation about system responses.
All the actuators' values can be changed at any time from the keyboard allowing the analysis about curves and responses of the whole process.
Shield and filtered signals to avoid external interferences.
Real time PID control with flexibility of modifications from the computer keyboard of the PID parameters, at any moment during the process.
Real time PID and on/off control for pumps, compressors, resistances, control valves, etc.
Real time PID control for parameters involved in the process simultaneously.
Proportional control, integral control and derivative control, based on the real PID mathematical formula, by changing the values, at any time, of the three control constants (proportional, integral and derivative constants).
Open control allowing modifications, at any moment and in real time, of parameters involved in the process simultaneously.
Analog and digital PID control. PID menu and set point selection required in the whole work range.
Possibility of automatization of the actuators involved in the process.
Management, processing, comparison and storage of data.
Sampling velocity up to 250 KS/s (kilo samples per second).
Calibration system for the sensors involved in the process.
It allows the registration of the alarms state and the graphic representation in real time.
Comparative analysis of the obtained data, after the process and modification of the conditions during the process.
Three safety levels, one mechanical in the unit, another electronic in the control interface and the third one in the control software.
The process can be controlled at any time, so the changes of any parameter, following different formulas, can be analysed in detail.
It is a MULTICONTROL SYSTEM, as several parameters and actuatots can be controlled at the same time (simultaneously). Example: 5 temperature sensors, 2 pressure sensors,1 flow sensor, a heating resistance power, etc.
This system allows the 30 students of the classroom to visualize simultaneously all the results and the manipulation of the unit, during the process, by using a projector or an electronic blackboard.
● Sensors and actuators in the teaching unit.
● Control interface box.
● Common and standard data acquisition board (PCI) placed in a computer slot.
● Software package specific for any teaching unit for: Control, Data acquisition and Data management.
